Roof retrofit 754 246 9312 adding clips or straps will save you money on hurricane insurance increase the value of your home and give you piece of mind.
Single wrap roof to wall connection.
In houses with masonry walls it is common to find a horizontal or flat wise 2x8 lumber plate that is bolted or strapped to the top of the masonry wall.
A single strap that is attached to the side and or bottom of the top plate and is nailed to the rafter truss.
Retrofitting from above through the roof.
In this article richard reynolds who helped write the new code language outlines the steps involved.
A single wrap that is not nailed properly gets dropped back to clips level if it has three nails on the front side.
Then the house wrap and exterior wall covering are installed over this roof flashing.
When your home is being re roofed there is a great opportunity to gain access to the roof to wall connection by removing roof sheathing at the eaves of the house and installing straps clips or right angle brackets to reinforce the connection between the roof structure and the walls.
And if the home does need a.
Roofing and roof repair roof clips roof to wall connections.
The best tie down discount is for double wraps which is either one single wrap on each side of the truss rafter or a single metal connector like the one shown below that is secured with a minimum of three nails on each.
Where required by section 101 2 511 4 the intersection of roof framing with the wall below shall be strengthened by adding metal connectors clips straps and fasteners such that the performance level equals or exceeds the uplift capacities as specified in table.
In addition the straps wrap over trusses or rafters and are secured with the properly number and size nails.
How to inspect the connections that tie existing rafters or trusses to the wall plate to determine whether retrofitting is needed.
There sometimes is a problem with movement differences of the wall and the roof decking when the flashing is fastened to both the wall and the roof.
A checklist to help you evaluate your roof to wall connections if you have a masonry house along with some guidance on the implications of what you find is available by clicking on masonry wall checklist.
Often with new construction the roof flashing is first nailed to the wall.
The metal does not wrap around the top of the rafter truss and the clip is only located on one side of the connection.